Advertisement
1999 Escort/Tracer Workshop Manual
39
7C355
Shift Lever Shaft
40
7L027
Oil Pan Magnet
41
—
Pin
1. Clean the transaxle exterior with solvent before disassembly.
2. Clean all removed parts (except sealed bearings) and all sealing surfaces with solvent, and dry with compressed air.
3.
WARNING: Using compressed air can cause dirt and other particles to fly out, causing injury to the eyes. Wear protective eye wear whenever using compressed
air.
Clean out all holes and passages with compressed air and verify that there are no obstructions.
4. Mount the transaxle on Bench Mounted Holding Fixture.
5. Remove the case cover.
1. Remove the bolts.
2. Remove the case cover.
6. Shift the transaxle into first gear.
7.
CAUTION: Do not reuse locknuts.
Use Input Shaft Holder to remove the input and output locknuts. Discard the input and output locknuts.
8. Remove the reverse synchronizer blocking ring retainer assembly.
1. Remove the spacer.
2. Remove the reverse synchronizer blocking ring retainer assembly.
9. Remove the reverse synchronizer blocking ring.
http://www.fordtechservice.dealerconnection.com/pubs/content/~WSXF/~MUS~LEN/19/...
Page 3 of 10
10/6/2009
Advertisement
