Calibration - Bryant TSTATCCPS101 Installation Instructions Manual

Sample Wiring Diagram
6 Wire, 1 Stage Cooling, 2 Stage Heat, Heat Pump *
O
W2 Y2 R W1 Y1 C
G
* The heat pump option must be selected
on during advanced setup.

Calibration

Every thermostat is calibrated before it leaves the factory.
Under normal circumstances there will never be a need to
recalibrate the thermostat again.
To accommodate special needs, the thermostat may be recalibrated
following these steps:
1. While holding the mode button in, press the fan button for
5 seconds. After all the icons in the display appear, release
the buttons.
2. Press the Up and Down buttons simultaneously, twice.
3. Press the up or down buttons until the flashing number
equals the current room temperature.
4. Press the mode button to return to normal operation.
Most residential split and package heat pumps
with auxiliary heat
Thermostat
24 vac common
fan relay
compressor relay
1st stage heat circuit
24 vac return
2nd stage heat circuit
Page 7
L
E
C
G
Y1
O
W1
R
Y2
W2