Install The Mirrors - Honda GL1800 Setup Instructions

2005 GL1800/A

8. Install the mirrors.

Installation of the mirrors includes installing a
stay for the inner cowling on both sides. The
right-hand stay is marked with an "R" .
Mount each stay on top of the mirror mount.
Loosely install the mirror assembly (on both
sides) using a 5 x 20 mm screw/washer in the
top mounting hole.
Set a cowl stay (be sure of the correct side)
on the top of the lower mirror mounts and
attach the mirrors using two 5 x 20 mm
screws and washers.
Attach the inner cowling to the cowl stay
using a 5 x 12 mm special bolt (both sides).
Connect the turn signal connectors
(on both sides).
Repeat the procedure for the opposite side
and tighten all six screws.
Lubricate the mirror boot tabs with soapy
water and press them into place (two at the
top and three at the bottom) in the garnish.
9. Install the auxillary input patch cord.
A length of wire is enclosed with the
Owner's Manual pouch. This wire is a
patch cord that owners can use to attach a
personal stereo (CD player, MP3 player, etc.)
to the motorcycle.
Remove the left hand fairing pocket to reveal
the wiring boot where the headset DIN
connector is plugged. Contained within the
boot is a white three-pin connector to be used
with the patch cord. Run the wire through the
bottom of the fairing pocket with the enclosed
grommet; the cord can then be plugged into
the headset outlet of the personal stereo. This
allows the personal stereo to be played
through the motorcycle's external speakers or
optional headsets.
8
MIRROR
MIRROR
BOOT
TURN SIGNAL
CONNECTORS
LEFT FAIRING POCKET
TRIM CLIPS
©2004 American Honda Motor Co., Inc. - All Rights Reserved
COWL STAY
5 X 20 mm
SCREWS
5 X 20 mm
SCREW