Honda GL1800 Setup Instructions page 8

7. Install the windshield.
Remove a bolt, washer, and grommet from
each side of the garnish. Carefully pull the
garnish studs (four places) from their
grommets and remove the garnish.
Loosen the 5 mm cross-recess screw and
rotate the air vent cover to access the small
head windshield holder mounting bolt.
Remove the small head 6 mm windshield
holder bolt.
Remove the two 6 mm nuts (one each side)
attaching the windshield holder to the
windshield locking mechanism and remove
the holder.
©2004 American Honda Motor Co., Inc. - All Rights Reserved
BOLT, WASHER,
and GROMMET
GARNISH
6 mm
BOLT
AIR VENT
COVER
WINDSHIELD
LOCKING
MECHANISM
5 mm
SCREW
6 mm NUT
(EACH SIDE)
5