Troubleshooting - Weldex WDAC-5700C Operation Manual

18
7.7 SPECIAL
CONTRAST : You can adjust contrast on screen. (0 ~ 255 steps)
SHARPNESS : You can adjust sharpness on screen. (0 ~ 31 steps)
DISPLAY : You can adjust display. (CRT / LCD / USER)
CRT (Cathode Ray Tube, Braun tube)
PED LEVEL : 0 ~ 63 steps
COLOR GAIN : 0 ~ 255 steps
LCD (Liquid Crystal Display)
GAMMA : 0.05 ~ 1.00 steps
PED LEVEL : 0 ~ 63 steps
COLOR GAIN : 0 ~ 255 steps
USER
GAMMA : 0.05 ~ 1.00 steps
PED LEVEL : 0 ~ 63 steps
COLOR GAIN : 0 ~ 255 steps
NEG.IMAGE : You can select negative display. (OFF/ON)
Digital BOX Camera Installation Guide

8 TROUBLESHOOTING

If there are problems in operation, please refer to the items below.
If the problem persists, please contact the agent you purchased this product from.
Problems
Nothing appears on the screen.
The video image is not clear.
The screen is dark.
The MOTION DETECTION
function is not working
7.7 SPECIAL
SPECIAL
CAM TITLE
MOTION
PRIVACY
PARK.LINET
IMAGE ADJ.
COMM ADJ.
LANGUAGE
VERSION
RETURN
COMM ADJ. : You can adjust command.
CAM ID : Select the camera ID
0 ~ 255
BAUD RATE : Select serial communication speed.
2400 / 4800 / 9600 / 19200 / 38400 / 57600 bps
PROTOCOL : Select operating protocol
PELCO-D / PELCO-P
DISPLAY ID : Select display item.
OFF/ON
ID POS : You can adjust ID position on screen.
LANGUAGE : You can select language
ENGLISH / CHINESE
VERSION : Factory vision.
RESET : Factory default reset.
Troubleshooting
Please check the power connection.
Please check the video signal line connection.
Please check and make sure that the lens mode is set to DC (VIDEO) when using a VIDEO (DC) lens.
Please clean the lens with a clean cloth or brush.
Please adjust that the screen is not exposed directly to a bright light.
Please move the camera if necessary.
Please readjust the back-focus of the camera.
Please adjust the contrast feature of the monitor.
If you have an intermediate device, set the 75Ω /Hi-Z properly, and check the terminals.
Please check if an auto iris lens is being used and adjust the brightness level.
Please check if "MOTION DETECTION" mode is turned on.
Please check if the MD Sensitivity is too low.
Please check the setting of the MD AREA.
Digital BOX Camera Installation Guide
COMM ADJ.
OFF CAM ID
OFF BAUD RATE
OFF PROTOCOL
OFF DISPLAY ID
ID POS
RETURN
ENGLISH
21 01 10
RET
001
9600
PELCO-D
OFF
RET
19