How To Replace; Power Match ® Noses - Oregon Chain Saw Maintenance & Safety Manual

HOW TO REPLACE OREGON
NOTE: Select a new Power Match
bar and chain. Reduced-kickback Double Guard
can be installed on any Power Match® bar and can be used with the
same drive-link-count loop of chain.
1. Note that your OREGON
side only, with an "X." Always strike on the "X"-stamped side of Power
Match bar noses. Striking on the wrong side will damage the nose and
®
bar body. Use the Power Match
drive ou the single attaching rivet.
"X" Side Up
2. Remove the old nose. Clean the bar's attachment area.
3. Insert the new nose into the bar body. Insert the Power Match
(part n°.34726) through the underside of the nose, opposite the "X"
mark.
NOTE: The rivet will not fit, and cannot be secured, if inserted through
the "X" side.
58.
58.
58.
BAR NOSES
®
Power Match bar nose is marked, on one
®
®
"X" Side Up
Guide Bars
POWER MATCH
®
nose with the correct pitch for your
®
nose-rivet punch (part n°.35518) to
®
replacement noses
rivet
®
"X" Side Up