Oregon Chain Saw Maintenance & Safety Manual page 25

HOW TO INSTALL NEW CHAIN PARTS
™
Assemble chain to the preset tie strap.
š
Assemble tie strap with brandmark or
Lubrilink™ contour face up, and the notch
toward the drive-link tangs. Assemble bum-
per tie strap in the correct direction, with the
notch toward the drive-link tangs.
›
Be sure parts are assembled in the correct location, sequence and
direction. Check the illustrations on pages 2 and 3. If unsure, ask your
OREGON dealer.
®
œ
To form rivet heads, use an OREGON
tions packaged with the rivet spinner.
CAUTION:
Rivet heads must be snug and secure while still allowing all joined
parts to move freely. Rapid wear leading to possible chain breakage
and personal injury can be caused by rivet heads that are either too
tight, or too loose.
NOTE: New rivet heads may be smaller and shaped differently than
factory-spun heads.
Saw Chains
rivet spinner. Follow the instruc-
®
21.