How To Install Chain Parts - Oregon Chain Saw Maintenance & Safety Manual

HOW TO INSTALL NEW CHAIN PARTS
Read the warnings on page 12.
NOTE:
• Use only OREGON
parts which are the correct size and type for your chain.
–
Remove rivets, and parts to be replaced, as shown under "How to
Break Out Rivets," pages 22 to 23. Never reassemble a chain with
old preset tie straps - always use new preset tie straps.
—
If needed, file off bottom of new parts to match existing worn parts.
File new cutters back to match worn cutters. Do not file the tops of
kickback-reducing bumper tie straps or bumper drive links.
˜
Place the preset tie strap on a flat outer
surface of a chain-breaker anvil. Be
sure the rivets are pointing up.
20.
Saw Chains
parts to repair OREGON
®
chain. And only use
®