About Average Reading; About Pressure Rating Indicator; About Memory - LifeSource UB-521CN Instruction Manual

aBoUt avEraGE rEaDinG

The UB-521CN provides an average blood pressure reading
based on the total measurements stored in memory. When
taking a measurement, the average blood pressure reading
will appear and the number of measurements stored in
memory will flash several times before the cuff begins
to inflate. The average blood pressure reading will also
appear briefly when you recall the measurements stored in
memory.

aBoUt prESSUrE ratinG inDiCator™

The Pressure Rating Indicator™ is a feature
which provides a snapshot of your blood pressure
classification based on your measurements.
This will let you quickly know what your blood
pressure readings mean. Each segment of the bar
indicator corresponds to the Seventh Report of the
Joint National Committee (JNC7) on Prevention,
Evaluation and Treatment of High Blood Pressure
from the National Heart, Lung and Blood Institute
- May 2003. For a more detailed look at this blood
pressure classification, please refer to "Assessing
High Blood Pressure" on page E-11.
:The indicator displays a segment, based on the current measurement,
corresponding to the JNC7 Classification.
NoTE: Due to other risk factors (e.g. diabetes, obesity, smoking, etc.) in addition to your
blood pressure measurement, the Pressure Rating Indicator is approximate. Please consult
with your physician for interpretation and diagnosis of your blood pressure measurements.
NoTE: Residents outside of the United States (e.g.. Canada and Mexico) should refer
to the WHO Classification Table on page E-11 for assessment of their blood pressure
measurement.
LifeSource Health Line (Toll-Free): 1-888-726-9966
E-8
aVeRaGe
NuMBeR of MeasuReMeNTs sToRed IN MeMoRy
The UB-521CN automatically stores up to (90) blood pressure and pulse
measurements in its memory. Measurements stored in memory are
assigned an index number in the order of the newest to the oldest. The
oldest reading displays as "n01".
To retrieve readings, follow these simple steps:
1.
When the display screen is blank, press and hold the
START button. While holding down the START button,
you will see the average reading displayed first. You
will then see the memory index number (e.g. n04) of
the most recent reading followed by the measurement.
Release the START button when you see the memory
index number.
2.
The display will shut off automatically a few seconds
after all of the readings are displayed. To turn off the
monitor at any time, press the START button.
3.
The display will shut off automatically a few seconds
after the readings are displayed.
If there are no measurements stored in memory, two 0s
displayed vertically followed by a blinking "A00"
To clear the measurement history from memory,
remove the battery from the unit and then place the
battery back into the battery holder.
NoTE: Memory will be lost if batteries become low or are removed.
In Canada–Auto Control Medical (Toll-Free): 1-800-461-0991

aBoUt mEmorY

E-9