Advertisement
1965_Bell_Aud_PC5050_GSG_E_r14
s e t t i n g u p y o u r
Step 1 : Charge the battery
i. Insert the AC adapter into the
back of the cradle, and then plug
into external power source.
ii. Dock your Pocket PC in its
cradle and fully charge for
approximately 4 hours -
A steady amber LED
indicates charging; solid
green fully charged.
Note
• For charging the built-in battery, maintain an ambient temperature from
approx. 5°C (41°F) to 35°C (95°F). If the ambient temperature is too low
or too high, the charging will pause. According to the operating status,
the charging may pause even when the ambient temperature is below
35°C (95°F). The flashing in yellow of the charging LED indicates the
pause of the charging.
• Charge time is dependent on the ambient temperature.
• Charging time to fully charge the built-in battery for the first time or
when completely drained is approximately 4 hours.
4
3/19/04
2:59 PM
5 0 5 0
p p c -
Page 4
Step 2 : Remove the stylus
1. Remove the stylus from its slot on the back of
the device.
Step 3 : Follow the set up wizard
1. When charging is completed, press the Power
button to turn on the power. The welcome
screen appears.
2. Proceed with initial set up following the on
screen instructions.
i. When the 'complete' screen appears, the
initial set up is done.
ii. Tap the screen to begin using your
PPC-5050.
5
Advertisement
