Elation STAGE SETTER-8 User Instructions page 11

Stage Setter 8™
Rear Panel - Controls and Functions (Cont.)
21. MIDI Thru:
This jack is used to parallel an incoming MIDI signal through to another
MIDI device.
22. MIDI In:
This jack receives an incoming MIDI signal from external MIDI control-
ler or keyboard.
23. Fog Machine Connector:
Use this connection to connect a compatible Elation fog machine, such
as the Master Blaster 700 and 1000, Vaporizer, and the Dyno Fog. This
eliminate the need of separate controller.
Elation Professional - www.elationlighting.com - Stage Setter 8™ Instruction Manual Page 14
®
Controls and Functions Stage Setter 8™
Front Panel - Controls and Functions (Cont.)
In 1x16 mode, each button can be programmed to control a group of
channels, this makes each button a Flash Scene.
The Bump Buttons are also used in programming mode, when pro-
gramming Flash Scenes and Master Scenes.
11. Scene Y:
These 8 sliders are used to control the intensities of channel 9-16 (11).
The overall intensity of channel faders 9-16 (11) is controlled by the X
Crossfader (5).
12. Built-in Patterns 9-12:
These four Patterns buttons are used to activate any of the four built in
programs stored in the unit's memory. A pattern LED will glow when a
corresponding pattern was selected for operation.
13. Tap Sync:
This button is used to create a chase rate. Repeatedly tapping this
button will establish a chase rate that corresponds to your tap rate. The
chase rate will be synchronized to the time interval of the last two taps.
A Tap Sync LED will flash at the established chase rate. A chase rate
may be set at anytime, weather a chase pattern is running or not.
The Tap Sync Button also activates Step Mode. Holding the Tap Sync
button down for at least five seconds will activate Step Mode. To deac-
tivate Step Mode hold down the Tap Sync button for five seconds.
14. Full On Button:
This button is used to bring all channel output (1-16) to full intensity.
This function will override the Blackout (15) function. A Full On LED (14)
will glow when Full On (14) is active.
15. Blackout Button:
This button is used to disable all channel output (1-16). Only the Full
On (14) and Bump Buttons (10) function can override this function.
Blackout is active when the Blackout LED is glowing.
Elation - www.elationlighting.com - Stage Setter 8™ Instruction Manual Page 11
© ®
Controls and Functions