TANDBERG Profile Administrator's Manual page 70

Profile 42" with Codec C20
!40-%0-& :0-(4*,6-/40
Contents Introduction
,-./012'34511'6.789':297,
Profile wall mount setup
!"#$%&'"(%'#)'*%+",$-'%./-/01'
-2%'&)&-%3'40'(/12-'&/*%5'#,-'
6"0'%"&/$)'#%'&7/-26%*'-4'$%+-'
&/*%8
WARNING!
Due to the size and mass of this equipment, it is very important that
the wall mount unit is safely installed according to the installation
instructions and that the wall is able to safely support the product.
It is highly recommended that the wall mounted system is installed by
trained personnel
D14554.01—OCTOBER 2009
9%--/01'&-"(-%* =#4,-'-2%'3%0,&
Getting started About the menus
!"#
$%&'''' (&
)(#
Mounting
Use the Allen key, which is found in the foot box, when fastening the
wall brackets to the bottom module with four M6x10 screws
Place the bottom module by the wall, mark where to bolt the bracket
and move away the bottom module
NOTE! Use a level to make sure the system is mounted in an upright
position. Add a spacer between the wall bracket and the wall if
necessary.
;2%'<%--/01&'3%0, ;2%'<%--/01&'$/#("()
The settings menu Settings Library
Administrator Guide
!"3%("& !""#$%&'#( =>>%0*/6%&
Cameras Appendices
Add the suitable fixing device for the screws in the wall
Open the rear door and locate and connect the cables which are
lead out of the system at the rear side (the door is not accessible
when placed by the wall)
Place the bottom module by the wall and bolt it to the wall.
!40-"6-',&
Contact us
70