Table of Contents
Advertisement
Order Parts Here:
www.ivie-ent.com/parts
Ph:(918)254-5161
Operator's Manual
Manual del Operador
Manuel de l'operateur
READ THIS BOOK
This book has important information for the use and safe operation of this machine. Failure to read this
book prior to operating or attempting any service or maintenance procedure to your Clarke machine
could result in injury to you or to other personnel; damage to the machine or to other property could occur
as well. You must have training in the operation of this machine before using it. If your operator(s) cannot
read English, have this manual explained fully before attempting to operate this machine.
Si Ud. o sus operadores no pueden leer el Inglés, se hagan explicar este manual completamente antes
de tratar el manejo o servicio de esta máquina.
All directions given in this book are as seen from the operator's position at the rear of the machine.
For new books write to: Clarke
Form No. 70416A
7/06
®
, 2100 Highway 265, Springdale, Arkansas 72764.
Clarke
BEXT
150H, 300HV
Extractor's
®
®
-100, 100H,
120V
Printed in the U.S.A.
Advertisement
Table of Contents
Related Manuals for Clarke BEXT 100H
Summary of Contents for Clarke BEXT 100H
- Page 1 This book has important information for the use and safe operation of this machine. Failure to read this book prior to operating or attempting any service or maintenance procedure to your Clarke machine could result in injury to you or to other personnel; damage to the machine or to other property could occur as well.
-
Page 2: Table Of Contents
-100 Accessories .................... 42 ® -100H Accessories ..................43 ® -150H Accessories ..................44 ® -300HV Accessories ..................45 ® Control Panel Wiring Diagram ................. 46 Electrical Schematic 120V ..................47 ® Clarke ® Page 2 -100, 100H 150H, 300HV Operator's Manual... -
Page 3: Operator Safety Instructions
WARNING: Keep all fasteners tight. Keep the adjustments according to specifications. WARNING: Make sure that all the labels, decals, warnings, cautions and instructions are fastened to the machine. Replace them when necessary by ordering them from Clarke. ° ° WARNING:... -
Page 4: Introduction And Machine Specifications
3. Do not allow children or pets to crawl or walk around on the damp carpet. 4. Vacuum right after the carpet is dry and then vacuum the carpet once a week as needed. ® Clarke ® Page 6 -100, 100H 150H, 300HV Operator's Manual... -
Page 5: Controls And Machine Features
The Machine Power Cord (Red "H") See Figure 1I This cord powers all machine functions except the heater. The Heater Power Cord See Figure 1J This cord powers heater only. Figure 2 ® Clarke ® Page 12 -100, 100H 150H, 300HV Operator's Manual... -
Page 6: How To Prepare The Machine For Operation
Try other outlets until the light comes on. CAUTION: If both cords are plugged into the same circuit breaker, the breaker may blow when operating with the heater ® Clarke ® Page 14 -100, 100H 150H, 300HV Operator's Manual... -
Page 7: Ext -100 Control Panel
PUMP SWITCH (3): This switch will illuminate when the pump is on. HEAT SWITCH (4): The heat switch will illuminate when it is activated and will turn the heater on. ® Clarke ® Page 16 -100, 100H 150H, 300HV Operator's Manual... -
Page 8: Ext -150H Control Panel
See previous page for additional information on the circuit locator. HEAT LIGHT MODE ( 6 ) : The light will only illuminate when the heater uis heating and will turn off when it reaches operating temperature. ® Clarke ® Page 18 -100, 100H 150H, 300HV Operator's Manual... -
Page 9: Extension Cords - 120V
If you use an extension cord, use one that has a minimum wire size of 12 AWG. Be sure your extension cord is no longer than 50 ft. Do not join two extension cords. ® Clarke ® Page 20 -100, 100H 150H, 300HV Operator's Manual... -
Page 10: Machine Operating Instructions
8. As you make passes, repeat one inch of the area already cleaned. 9. Make more passes until all of the room is cleaned. CAUTION: Clarke will not be held liable for damage to the carpet, or poor results because of the operator's lack of ability. ®... -
Page 11: Maintenance
WARNING: Maintenance and repairs must be done by authorized person- nel only. Keep all fasteners tight. Use only genuine Clarke parts. WARNING: Do not operate this machine un- less it is completely assembled. NOTE: For maintenance of the floor tools read the manual given with the tools. -
Page 12: How To Prevent Damage From Freezing Temperatures
(see figures 9a & 9b): 1. Empty both tanks. 2. Unlatch tanks from base. 3. Tilt tanks back. 4. Disconnect hoses from tanks. 5. Open up for service. ® Clarke ® Page 26 -100, 100H 150H, 300HV Operator's Manual... -
Page 13: How To Check The Commutator And The Carbon Brushes
5. Disconnect the ground wire. 6. Remove the plastic motor cover. 7. Inspect the commutator. See figure 10. Take the IRREGULAR AGUJEROS machine to a Clarke authorized repair location if you EN BUEN EN BUEN PEQUEÑOS see any of the following conditions:... -
Page 14: How To Correct Problems In The Machine
2. There is too much foam. 2. Put defoamer in the solution. Order P/N 398420. 3. The float gasket is dirty or damaged. 3. Clean the gasket. Replace if damaged. ® Clarke ® Page 30 -100, 100H 150H, 300HV Operator's Manual... - Page 15 100, 100H, 150H, 300HV ® Extractor Section II Parts and Service Manual (70416A) ® Clarke ® -100, 100H 150H, 300HV Operator's Manual Page 33...
-
Page 16: B -100 Assembly Drawing
® Clarke -100, 120V ® Assembly Drawing 7/06 ® Clarke ® Page 34 -100, 100H 150H, 300HV Operator's Manual... - Page 17 ® Clarke -100, 120V ® Assembly Drawing Parts List 7/06 Ref # Part No. Description Ref # Part No. Description 53876A Drain Gate 80335A Lock Nut, ¼-20 80331A Screw, 8-32 x " 53885A Quick Disconnect, Male ¼ PT 52636A Latch...
- Page 18 ® Clarke -100H, 120V ® Assembly Drawing 7/06 ® Clarke ® Page 36 -100, 100H 150H, 300HV Operator's Manual...
- Page 19 ® Clarke -100H, 120V ® Assembly Drawing Parts List 7/06 Ref # Part No. Description Ref # Part No. Description 53876A Drain Gate 80335A Lock Nut, ¼-20 80331A Screw, 8-32 x " 80340A Quick Disconnect, Male ¼ PT 52636A Latch...
- Page 20 ® Clarke -150H, 120V ® Assembly Drawing 11/05 ® Clarke ® Page 38 -100, 100H 150H, 300HV Operator's Manual...
-
Page 21: Parts List 3/06
® Clarke -150H, 120V ® Parts List 3/06 Ref # Part No. Description Ref # Part No. Description 59721A Valve-Drain 962098 Screw, ¼ -20 x 3/4 53606A Elbow-45 Degree, Drain 52840A Quick Disconnect 962929 Screw, 10-32 x 52672A Flange, Exhaust... - Page 22 ® Clarke -300HV, 120V ® Assembly Drawing 11/05 ® Clarke ® Page 40 -100, 100H 150H, 300HV Operator's Manual...
-
Page 23: Parts List 3/06
Heat Repair Kit w/Thermostat & Cutout Asm. * Items 6, 7 & 104 must be ordered as a set when replacing any original Label, Clarke #6 Adapter and: 3 - 85522A Screws, 1 - 962109 Screw, 1 - 920296 Nut. -
Page 24: Bext
Clarke ® -100 Accessories ® Drawing & Parts List 3/06 WARNING : Do not use Bext 100 accessories on heated units (Bext 100H, 150H & 300HV). Injury to operator or bystanders could occur. Damage to the machine could occur. Part No. -
Page 25: Bext
Clarke ® 100H, 150H Detailer Accessories ® Drawing & Parts List 6/04 9 11 Part No. Description 61394A 12" Wand 30496A Hose Asm., Solution 52544A Valve Body 52996A Nozzle, Spray 52469A Hose 15' 52833A Tool, 3½ HP 398426 Defoamer *1 case... -
Page 26: Bext
Clarke ® 300HV Accessories ® Drawing & Parts List 1/04 Part No. Description 61395A 12" Wand 30496A Hose Asm., Solution 52544A Valve Body 52996A Nozzle, Spray 52469A Hose 15' 52833A Tool, 3½ HP 398426 Defoamer *1 case 398425 Extractor, Concentrate... -
Page 27: Wiring Diagram
Clarke ® -150H, 120V ® Wiring Diagram 10/01 BEXT-150H EXTRACTOR WIRING DIAGRAM 120V BLACK CORD 1 WHITE GROUND ORANGE VAC 1 VAC 2 ORANGE WHITE BLUE PUMP DUAL CORD BLACK SENSOR BYPASS SWITCH CIRCUIT BOARD MODE LIGHT BLACK LOCATOR LIGHT...
Need help?
Do you have a question about the BEXT 100H and is the answer not in the manual?
Questions and answers