Garmin nuvi 705 series Quick Start Manual page 74

Appendix
Problem/Question
My battery gauge does
not seem accurate.
My phone will not
connect to the nüvi.
How do I know my nüvi
is in USB mass storage
mode?
My computer never
senses that the nüvi is
connected.
I cannot see any new
removable drives in my
list of drives.
I cannot get traffic
information.
0
Solution/Answer
Allow the unit to fully discharge, and then fully charge it (without
interrupting the charge cycle).
Bluetooth wireless technology is not available on nüvi 755.
Touch Tools > Settings
is set to Enabled.
Make sure your phone is turned on and is less than 10 meters
(about 33 feet) away from your nüvi.
Go to www.garmin.com/bluetooth
When your nüvi is in USB mass storage mode, a picture of a nüvi
connected to a computer is shown. Also, you should see two new
removable disk drives listed in
1. Unplug the USB cable from your computer.
2. Turn the nüvi off.
3. Plug the USB cable into your computer and your nüvi. The nüvi
automatically turns on and goes into USB mass storage mode.
If you have several network drives mapped on your computer,
Windows may have trouble assigning drive letters to your nüvi
drives. See the operating system Help file to learn how to map/
assign drive letters.
Verify that you are in a coverage area. You must be in a coverage
area to get the traffic information for that area.
Verify that the FM TMC Traffic receiver is connected to the power
connector on the cradle and also connected to a power outlet in
your vehicle. (The traffic receiver is included in some nüvi 755 and
765 packages.)
> Bluetooth. Verify that the Bluetooth field
for more help.
My Computer.
nüvi 705 Series Owner's Manual