Metrologic Optimus PDA SP5700 Series Quick Start Manual page 5

Software/Hardware Reset
Under certain circumstances a Software or Hardware reset may be needed to be performed on your PDA. The below tables explain
how to perform a software or hardware reset.
Press Reset button on the rear of
the PDA using the Stylus Pen
Software
Reset
Only use the Stylus Pen provided to press the Reset button.
Using sharp objects may cause damage to the PDA.
PC Synchronization
To communicate with a host PC, connect the PDA to the PC and run ActiveSync.
Connection can be made via the Vehicle Cradle, Trigger Handle or either of the charging cradles.
ActiveSync software can be downloaded from
Optimal Scanning Direction
• For Optimal scanning, hold the base of the barcode just below the PDA scanning unit.
• Press and hold either scan button until the scan is complete
Optimus PDA SP5700series Quick Start Guide
Reset
Press the Sync Button on the 4
slot cradle to sync PDA with PC.
http://www.microsoft.com
Press Power button and Reset
button simultaneously
Hardware
Reset
for installation on your PC.
Laser
Imager
Barcode
Reset
OK X