Operating Instructions; General Instructions; Control Buttons - Gateway FPD1960 Service Manual

3. OPERATING INSTRUCTIONS

3.1 GENERAL INSTRUCTIONS

Press the power button to turn the monitor on or off. The other control buttons are located in the side of the
monitor. By changing these settings, the picture can be adjusted to your personal preferences.
The power cord should be connected.
-
Connect the video cable from the monitor to the video card.
-
Press the power button to turn on the monitor, the power indicator will light up.
-

3.2 CONTROL BUTTONS

- Power Button:
When pressed, the monitor enters the off mode, and the LED turns blank. Press again to restore normal status.
- Left / Right Button:
The Left/Right Button is used to control the monitor functions. Press to switch functions or adjust settings.
- Auto Adjust Key:
The Auto Adjust Key is used to automatically set the H Position, V Position, Clock and Phase.
- Power Indicator:
Blue — Power On mode.
Orange — Power Saving mode.
Blank —Power Off Mode.
NO. Name
1 Input
2
Auto
3
4
5 MENU
Back to previous menu
Select Function or enter Sub menu
1.Move the cursor up
/ ▲
2.Increase the value of the selected item
1.Move the cursor down
/ ▼
2.Decrease the value of the selected item
Exit the OSD menu
Within OSD
6
Gateway FPD1960
①
②
③
④
⑤
⑥
Without OSD
Select input signal: Analog or Digital
Auto configuration
Activate the Brightness menu
Activate the contrast menu
Activate the OSD menu