Gateway FPD1975W Setup Manual

SETTING UP YOUR GATEWAY MONITOR
1 1
Connect the monitor base Connect the monitor base
Slide the neck onto the base until it snaps into place. Slide the neck onto the base until it snaps into place.
3 3
Plug in the monitor Plug in the monitor
To protect your monitor from power fluctuations, use a surge protector. To protect your monitor from power fluctuations, use a surge protector.
© 2006 Gateway, Inc. All rights reserved. Gateway is a trademark or registered trademark of Gateway, Inc. in the U.S. and other countries. Product specifications subject to change without notice. Actual product may vary from image shown.
2 2
Connect your monitor to your computer Connect your monitor to your computer
Follow the instructions that came with your computer. Follow the instructions that came with your computer.
Analog VGA Digital DVI
(supplied) (optional*)
4 4
Turn on the monitor and install software. Turn on the monitor and install software.
Insert the Ez Tune™ CD into your computer and follow the on-screeen instructions. Insert the Ez Tune™ CD into your computer and follow the on-screeen instructions.
Connecting Your Flat Panel LCD Speaker Bar (optional)*
1
Tilt the screen back,
center the speaker bar
below the screen, then
tighten the thumb
screws.
2
Connect the USB
power cord to a USB
port on your computer.
3
Connect the speaker
bar' s headphone and
microphone cables to
your computer, then
turn on the speaker.
* Available at www.gateway.com