Snare Drum - Canon creative park Service Manual

Drum set : Assembly Instructions
PAGE09
Floor tom
*Align the reverse sides and attach.
PAGE10

Snare drum

*Before attaching parts 10R and 10S, bend them into shape as shown in the diagram.
PAGE06
Head
Lug
Shell
Leg
Rubber foot
*Begin from the opposite
side to the seam.
Upper part
Seam
*NB: There are 8 10T parts altogether.
Align the marker lines on 10A
and 10B with the glue spots on
10C ~ 10H, and attach.
*Do not apply glue to .
PAGE11
Snare drum
Lower part
Upper part
*Be sure to align the thick black marker lines
on the top and bottom (circled here in blue)
when attaching.
*Take note of where
the thick marker line is.
Lower part
Snare wire picture
Lower part
*Align the snare
wire position here.
Align the snare wire position and fit the head on.
Do not apply glue.
Snare wire position
*After completing the
stand, place the snare
Shell
drum on the arm.
Do not apply glue.
Rubber arm
Stand
*Align the reverse
sides and attach.
Rubber foot
*Roll up and attach.
*Roll up and attach.
Upper part
Head
Lug