Tecumseh HM80 Operator's Manual page 19

PIN 1901514 (5192)
IMPORTANT!
See Instructions on Page 11 of Owner/Operator Manual
to Properly Install Gear Shift Lever Cable.
*
The transaxle shifting arm shown in figure at right is
preset in 4th gear position. 00 not move transaxle
shifting arm before installing cable.
*
When installing gear shift lever cable, route cable
b.e.1ID' l
handlebar.
*
After installing the gear shift lever cable and the wheel
drive bail cable, be sure to install the two cable ties
exactly as described in Step 5-0 on Page 11.
*
If agear shifting problem (loss of gear range, difficult
shifting, etc.) occurs during operation, check that the
cable clamp screw
is not loose. If screw is loose,
reinstall cable by following Steps 1 and 2 and 8 through
14 of the "Replacing Gear Shift Lever Cable" instructions
on Pages 44-45 of your Owner/Operator Manual.
*
If gear shift lever cable is properly installed as described above and transmission doesn't perform
correctly (poor traction, little difference in ground speeds in different gears, etc.), adjust the wheel drive
cable. See Page 42 (Figure 5-11) of your Owner/Operator Manual for full details.
*
To avoid serious personal injury, do not install or remove parts or make any adjustments to this
machine unless the engine is shut off, the spark plug wire is disconnected from the spark plug, and all
moving parts have come to a complete stop.