Yamaha A-S2000 Owner's Manual page 31

FCC INFORMATION (for US customers)
IMPORTANT NOTICE: DO NOT MODIFY THIS
UNIT!
This product, when installed as indicated in the
instructions contained in this manual, meets FCC
requirelllents. Moditications not expressly approved hy
Yamaha Illay void your authority. granted hy the FCC. to
use the product.
2 IMPORTANT: When connecting this product to
accessories and/or another product use only high quality
shielded cables. Cable/s supplied with this product MUST
he used. Follow all installation instructions. Failure
to
follow instructions could void your FCC authorization to
use this product in the USA.
3 NOTE: This product has been tested and found to comply
with the requirements listed in FCC Regulations. Part 15
I()r Class "B" digital devices. Compliance with these
requirements provides a reasonable level of assurance that
your use of this product in a residential environment will
not result in harmful interference with other electronic
devices.
This equipment generates/uses radio frequencies and, if
not installed and used according to the instructions found
in the users manual, may cause interference harmful
to
the
operation of other electronic devices.
• For U.K. customers
If the socket outlets in the home arc not suitable It)r the plug supplicd
with this appliance, it should be cut off and an appropriate 3 pin plug
lined. For details, refer to the instructions described below.
Note
The plug severed Irom the mains lead must be destroyed, as a plug
with bared flexible cord is hazardous if engaged in a live socket outlet.
Compliance with FCC regulations does not guarantee that
interference will not occur in all installations. If this
product is found to he the source of interference. which
can be determined by turning the unit "OFF" and "ON".
please try to eliminate the problem by using one of the
following measures:
Relocate either this product or the device that is heing
affected by the interferencc.
Utilize power outlets that are on different branch (circuit
breaker or fuse) circuits or install AC line tilter/s.
In the case of radio or TV interference. relocatelreorient
the antenna. If the antenna lead-in is 300 ohm rihhon lead.
change the lead-in to coaxial type cahle.
I I' these corrective measures do not produce satislilctory
results. please contact thc local retailer authorized to
distribute this type of product. I I' you can not locate the
appropriate retailer. please contact Yamaha Electronics
Corp., U.S.A. 6660 Orangethorpe Avc .. Buena Park. CA
90620.
The above statements apply ON LY to those products
distributed by Yamaha Corporation of America or its
subsidiaries.
• Special Instructions for U.K. Model
IMPORTANT
THE WIRES IN MAINS LEAD ARE COLOURED IN
ACCORDANCE WITH THE FOLLOWING CODE:
Blue: NEUTRAL
Brown: LIVE
As the colours of the wires in the mains lead of this apparatus
may not correspond with the coloured markings identifying
the terminals in your plug. proceed as follows:
The wire which is coloured BLUE must be connected
to
the
terminal which is marked with the letter N or coloured
BLACK. The wire which is coloured BROWN must be
connected to the terminal which is marked with the letter L or
coloured RED.
Making sure that neither core is connected to the earth
termin~1 of the three pin plug.
ii
En