Chimney (Flue) Cleaning; Blower Operation - Flame Energy ULC-S627 Manual

4.5

CHIMNEY (FLUE) CLEANING

Regular chimney (flue) maintenance, as well as good burning practices, are required to prevent
chimney fires. When wood (especially green wood) is burned without adequate heat or air supply, it
produces tar and other organic vapours (smoke), which combine with expelled moisture to form
creosote. The creosote vapours condense in the relatively cool chimney of a slow-burning fire. As a
result, creosote residues accumulate on the chimney. When ignited, this creosote makes an
extremely hot fire which could be hazardous. Your E.P.A Flame stove has been designed to reduce
the amount of creosote produced. Even so, the chimney and any chimney connector should be
inspected at least once every two months during the heating season to determine if a creosote
build-up has occurred. If creosote has accumulated, it should be removed to reduce the risk of a
chimney fire. Call a professional chimney sweep, or go to your local E.P.A Flame dealer, purchase a
chimney brush, and have the chimney cleaned.
Contact your local, municipal, state, or provincial fire authority for information on how to handle a
chimney fire before there is any chance that it may happen.
4.6

BLOWER OPERATION

If your stove has a fan or if you have install an optional blower, allow the stove time to reach its
operating temperature (approximately one hour), before starting the blower. The air blown by the
blower cools down the stove and affects the efficiency of the combustion when the blower is turned
on too quickly.
WARNING:
 TO PREVENT ELECTRIC SHOCK, MAKE SURE THE POWER CORD BLOWER IS NOT
IN CONTACT WITH ANY STOVE SURFACE. DO NOT RUN THE POWER CORD
BENEATH THE STOVE.
42