Flame Energy ULC-S627 Manual page 31

In order to prepare your stove for the connection to a fresh air kit, please follow the following steps
(this option is not available for the XVR and XLT series) :
1- Remove the back pedestal shield. Using pliers, remove ring (A) as shown below. Ring (A)
is a small piece of metal held by micro joints located inside the 3" (76mm) spigot on the
middle of the back pedestal shield.
2- Put the back pedestal shield in place using the 4 screws.
3- Connect a flexible insulated pipe to the 3" (76mm) spigot on the back pedestal shield. Secure
the pipe using pipe clamps. The complete fresh air kit is available at your Flame dealer.
A
31