Pioneer SD-533HD5 Training Manual page 48

8
Panel Adjustment for 480P
Start
1st FAC
INPUT
ADJUSTMENT 480P PANEL
TV CBL VCR DVD
TV /SAT /LD
/DTV
TV ANT
INPUT
1 2 3 4 3
FREEZE SPLIT SEARCH
SCREEN SUB CH
MODE SWAP SELECT
DISPLAY SLEEP
1 2 3
4 5 6
7 8 9
0 CH
ENTER
¢ CH
RETURN BRIGHT –24
CH VOL
MUTING
4
EDIT/ TV/SAT/DVD DTV/DVD TOP
LEARN MENU MENU
SOURCE DTV/SAT
5
POWER GUIDE
2 SET/ 3 Telop : Yellow
ENTER
DTV/(SAT)
8 ∞ INFO
VCR REC Data value
FAVORITE CH
1 7 3 ¡
RECEIVER
INPUT VOL VOL
Î
HDTV PROJECTION MONITOR
Note :
• The adjustment procedures are the same as those described in "
• Send the black burst of the 480P signal to the INPUT 1 connector.
• Send a 100%-white 480P signal to the INPUT 1 connector.
• When 480P signal is not obtained and adjustment does not complete, input a value the same as BRIGHT and the
CONTRAST data value that adjusted with step
After the adjustment was completed, perform the following operations.
(Purposes: To match the picture quality of SUB screen with MAIN screen by two screen display)
1 Observe R1058-GK of the G CRT DRIVE Assy with the oscilloscope (20V/div.).
2 Input the white 100% NTSC signal to the Composite input of INPUT 1.
3 Enter the 1ST Factory and press the 5 key of the remote control unit.
(The main unit receives the composite signal of INPUT 1 then.)
4 The screen changes to two screen display (split screen) by pressing the 7 key, and enter the SUB CONTRAST
Adjustment mode by pressing the 4 key.
5 Adjust VOL + or - keys so that the level of SUB screen becomes closest to the level of MAIN screen.
1H
MAIN
screen
• Mode for adjusting the brightness, contrast of the gray part (panel)
of the 4:3 normal screen of 480P signal.
<Data value section>
VOL
or
<Adjustment item section>
1 2
Panel Adjustment," except for the following:
.
SUB
screen
1 : BRIGHT (–64 to 63)
: CONTRAST (–64 to 63)
2
48.