Pioneer SD-533HD5 Training Manual page 41

In a case of an error in convergence:
Adjustable points
Good adjustment:
5 20 2
Bad adjustment:
-5 30 -3
2nd step
Adjust so that the vertical lines become straight, taking care to
preserve proper screen information volume and the linearity.
Adjust the right half of the screen first, then the left half.
(See 3.4.)
Right half : Adjust from the edge toward the center.
Left half : Adjust from the center toward the edge.
3rd step
Adjust so that the horizontal lines become straight. Adjust the
upper half of the screen first, then the lower half. (See 3.4.)
Upper half : Adjust from the edge toward the center.
Lower half : Adjust from the center toward the edge.
4th step
Repeat 2nd and 3rd steps to take total balance. Then the adjust-
ment for the green is completed.
To return from the fine adjustment mode to the coarse adjustment
mode, press the MENU key once, then the INPUT 4 key.
Note: When the MENU key is pressed to quit MANUAL
CONVERGENCE mode, the display will be unstable for
several seconds. This is because the adjustment data are
Adjustment
being written to the EEPROMs, and is not a malfunction.
data
Do not perform any operation (power on/off, or pressing
keys on the remote control unit or on the main unit, etc.)
during this period, because doing so may affect your
adjustment data.
Adjustment
data
3.5 Coarse Adjustment of the Red
After the green adjustment is completed, quit MANUAL
CONVERGENCE mode by pressing the MENU or MUTING
key, then press the INPUT 4 key three times to enter OFFSET
CONVER. MODE 3.
Select adjustment items for RH and RV, and roughly correct
distortion to converge with the green. Adjustment is required for
each screen mode
For adjustable items of the red and the blue, see the following
table.
Numeric Key RH
0 STATIC
1 SKEW
4
5 SUBPIN
6
7 LIN
8 SIZE
RV BH BV
STATIC STATIC STATIC
SKEW SKEW SKEW
KEY KEY
SUBPIN
PIN PIN
LIN LIN LIN
SIZE SIZE SIZE
41.