Transaxle Repair Parts 4/01 - Clarke Encore S20 Operator's Manual

2
1
14
Ref # Part No. Description
1 Screw, ¼-20
2 Washer, ¼ Lock
3 52660A Coupler
4 45044A Motor
5 69189A Transaxle Gearbox Assembly
6 Pin, Dowel
7 End Plate, Output
8 Magnet and Housing Assembly
9 Armature and Bearing Assembly
10 Washer, #10 Lock
11 Nut 10-32
12 Stud
13 52940A Commutator End Bell & Brush Asm.
14 51202A Mount, Bushing
Torque #1 80 inch pounds
Torque #11 40-45 inch pound tooth nuts
#12 Loctite #262
NOTE: Transaxle unit is sealed. No lubrication required
Page -54-
CLARKE TECHNOLOGY Encore L20

Transaxle Repair Parts 4/01

4
3
(COUPLER)
6
12
CLARKE TECHNOLOGY Operator's Manual -Encore S20/L20
14
5
7
9
8
10
3.06 dia.
11
Qty.
-
13
-
1
1
1
-
-
-
-
Commutator Endbell and
-
Brush Assembly
-
-
1
2
Installation Instructions:
1. With motor still fastened to transaxle gearbox,
remove old endbell by backing off the two 10-
32 nuts and removing the lock washers. Slide
endbell off motor.
2. Assemble new commutator endbell and brush
assembly by sliding it over shaft and motor
studs until brush retaining clip bottoms out.
Holding endbell still, slide retaining clip out from
between the brushes and commutator. Push
the endbell on the rest of the way until endbell
casting bottoms on the motor frame. Replace
the lock washers and nuts and torque the nuts
40-45 in.-lbs.