Clutch Lever; Brake Fluid - Honda 20010 VT1300CX Setup Instructions

2010 VT1300CX

CLUTCH LEVER

Measure the clutch lever freeplay at the end of the clutch lever.
CLUTCH LEVER FREEPLAY: 10 - 20 mm (3/8 - 13/16 in)
ADJUSTMENT
Adjust the clutch lever freeplay by the adjuster.
Make small adjustments at the lever end of the cable by loosening
the lock nut and turning the adjuster.
Tighten the lock nut after making the adjustment.
Before making any large adjustments, loosen the lever lock nut and
turn the adjuster all the way in.
Make large adjustments at the engine end of the cable.
Tighten the lock nut after making the adjustment.

BRAKE FLUID

Park the motorcycle on a level surface.
Turn the handlebar so the front brake reservoir is level and check
the brake fluid level mark.
Check the rear brake reservoir.
If the fluid level in either reservoir is low, remove the cap screws,
cap, plate, and diaphragm.
Add fresh Pro Honda DOT 4 Brake Fluid or equivalent from a sealed
container to bring the level up to the upper level.
• Brake fluid can cause irritation; avoid contact with the eyes and
skin.
• Handle brake fluid with care as it can cause damage to paint and
plastics.
Reinstall the diaphragm, plate, cap, and cap screws.
Tighten the cap screws to the specified torque.
Operate the brake lever and pedal.
If the freeplay is excessive, bleed the system.
FRONT CAP SCREW:
TORQUE: 1.5 N·m (0.15 kgf·m, 1.1 lbf·ft)
REAR COVER BOLT:
TORQUE: 10 N·m (1.0 kgf·m, 7 lbf·ft)
14
10-20 mm
(3/8 - 13/16 in)
LOCK NUT
ADJUSTER
CAPS
SCREW
CAP
CAP COVER
FRONT
REAR
BOLT