Mitsubishi Electric VS-45605 Technical Training Manual page 20

side the picture area (off the screen). If the Cursor is
located at these coordinates it will not be visible, and
must be moved to the visible area of the screen, us-
ing the ADJUST buttons.
Horizontal coordinates 0 and 7 are also off the screen.
However, they are close enough to the edge of the
screen so part of the cursor is visible. Adjusting the
vertical position at these points effects the horizon-
NOTES: ___________________________________________________________________________
__________________________________________________________________________________
__________________________________________________________________________________
__________________________________________________________________________________
__________________________________________________________________________________
tal cross hatch lines at the sides of the screen. The
same is true for vertical coordinate 8. Adjusting hori-
zontal position effects the vertical crosshatch lines
at the extreme bottom of the picture.
The shaded circles in Figure 3-3 indicate the cross-
hatch intersections that can be adjusted. There are a
total of sixty four cursor positions to make fine ad-
justments on the crosshatch.
Page 3-5