Mitsubishi Electric VS-45605 Technical Training Manual page 21

Moving the Cursor
The Cursor is moved using the ADJUST buttons.
The Cursor only stops at intersections that are as-
signed horizontal and vertical coordinates.
• ADJUST UP --- moves the Cursor to the
next upper active intersection
• ADJUST DN --- moves the Cursor to the
next lower active intersection
• ADJUST RGT --- moves to the next
active intersection on the right
• ADJUST LFT --- moves to the next active
intersection on the left
Adjusting Data
Pressing ENTER toggles the Cursor from the Move
to the Adjust Mode, the Cursor stops flashing. The
intersection at the Cursor, can be adjusted vertically
using the ADJUST UP & DN buttons, or horizon-
tally using the ADJUST LFT & RGT buttons.
The effect of Green Adjustments is illustrated in Fig-
ure 3-4A. In the Green mode, only Green is dis-
played, and moves when adjusted. Green is used to
correct raster distortion.
Page 3-6