Floor And Standing Type(Console) - Carrier ROOM AIR CONDITIONER Installation Manual

INSTALLATION INSTRUCTIONS
4.5 The Dimension of the Unit
Capacity
B C
A
12-18 990 660 206
Note:The dimension of 12000Btu/h and
18000Btu/h are the same.
5. Floor and Standing Type
(Console)
5.1 Accessories(Console)
Please check whether the following fittings
are of full scope. If there are some spare
fittings, please restore them carefully.
NAME
1.Hook
Installation
fittings
2. Magnetic ring
3. Remote controller
4. Frame
Remote
controller
& Its Frame
5. Mounting screw
(on some
(ST2.9 10-C-H)
models)
6. Alkaline dry batteries
(AM4)
7. Owner's manual
Others
8. Installation manual
Cautions on remote controller installation:
Never throw or beat the controller.
Before installation, operate the remote
controller to determine its location in a
reception range.
Keep the remote controller at least 1m apart
from the nearest TV set or stereo equipment.
(it is necessary to prevent image
disturbances or noise interferences.)
Do not install the remote controller in a place
exposed to direct sunlight or close to a
heating source, such as a stove.
Note that the positive and negative poles
are right positions when loading batteries.
Unit:mm
F G H
D E
907 200 203
505 506
SHAPE QUANTITY
2
1
1
1
2
2
1
1
.
This manual is subject to changes due to
technological improvement without
further notices.
SET TEMPERATURE?? O C)
AUTO FAN
COOL HIGH
DRY MED
HEAT LOW
TEMP.
ON/OFF FAN SPEED
MODE
SWING ECONOMIC TIMER ON
RESET LOCK TIMER OFF
AIR DIRECTION POWERFUL
Remote
controller
5.2 Inspecting and Handling the
unit(Console)
At delivery, the package should be
checked and any damage should be
reported immediately to the service agent.
When handling the unit, take into account
the following:
1. Fragile, handle the unit with care.
2. Keep the unit upright in order to
avoid compressor damage.
3. Choose on before hand the path along
which the unit is to be brought in.
4. Move this unit as originally package as
possible.
5. When lifting the unit , always use
protectors to prevent belt damage and
pay attention to the position of the
,
unit s centre of gravity.
5.3 Indoor Unit Installation(Console)
5.3.1 Installation place
The indoor unit should be installed in a
location that meets the following
requirements:
There is enough room for installation and
maintenance.
The outlet and the inlet are not impeded,
and the influence of external air is the
least.
The air flow can reach throughout the
room.
The connecting pipe and drainpipe could
be extracted out easily.
There is no direct radiation from heaters.
24
Mounting screw B
ST2.9x10-C-H
Remote controller
holder
Fig.50-1
(Refer to Fig.50-2 & Fig.50-3)