Installation Manual
Item #
Label
4
I
5
II
6
♫
7
I
8
II
9
I0I0
10
//
2.1.2
Rear Panel
The device's rear panel is shown in the figure below and described in the subsequent table.
Table 2-2: Mediant 600 Rear Panel Components Description
Item #
Label
100 - 240V
1
0.5A
50-60Hz
2
ESD
3
Version 6.0
Enlarged View of CPU (#3)
Dry contact port (normally open) - can be connected to an external audible or
visual alarm system (bell, siren, hooter, or light).
Dry contact port (normally closed) - can be connected to an external audible
or visual alarm system (bell, siren, hooter, or light).
Audio IN/OUT. (Currently, not applicable.)
10/100Base-TX Ethernet Port 1. (Two Ethernet ports provide a dual Ethernet
redundancy scheme, protecting against failure such as a disconnection of any
cable or associated LAN switch port.)
10/100Base-TX Ethernet Port 2. Refer to description above.
RS-232 port - for accessing the CLI and for receiving error / notification
messages. A 9-pin DB adapting cable is supplied.
Reset button - for resetting the device and optionally, for restoring the device's
parameters to their factory defaults (refer to 'Restoring Factory Default
Settings' on page 43).
Figure 2-2: Mediant 600 Rear Panel
AC power supply entry plug.
Electrostatic Discharge (ESD) socket - for attaching an anti-static wrist
strap to your wrist and to the ESD socket on the chassis.
Protective earthing screw.
Component Description
Component Description
13
2. Installing the Device
February 2010