Audio Issue; Vga Issue - SOYO SY-P4VGM V1.0 Quick Start Manual

After flashing the BIOS, my system will not boot-up.
1. Try clearing the CMOS RAM.
2. The BIOS chip is defective due to an unsuccessful flash, contact your nearest SOYO
branch for re-flashing.
Is there a way to reprogram my BIOS after an unsuccessful flash?
There is no other way, you need to send back the BIOS ROM to your nearest SOYO branch for
re-flashing.

VGA Issue

I cannot set my VGA to go higher than 16 color (640x 480).
1. Make sure that you have installed the VIA 4 in 1 driver set.
2. Install/ re-install the VGA driver.
After wake-up from Suspend to RAM or Standby mode, the screen has no display
but I can hear the hard disk operating (For External AGP card).
Check your VGA card's manufacturer for a driver and VGA BIOS update, make sure the VGA card
supports the Suspend to Ram function.

Audio Issue

How can I disable the on-board Audio?
Go to "Integrated Peripherals\VIA Onchip PCI Device" in the BIOS setup, then set the "AC97 Audio" to
disabled.
I cannot get the sound working on my system.
1. Check if the speaker wire is connected to the line out connector in the M/B.
2. Check if your speakers are powered on.
3. Install the audio driver supplied on our driver disc.
4. Check BIOS setup if "AC97 Audio" is enabled.
5. If sound already installed, check our website for an audio driver update.
The sound is working in my system, but when I play CD music from the CD-ROM, I
do not get any sound. What is wrong?
This is because the 4-wire audio cable from the CD-ROM to the on-board CDIN connector or AUX
connector on the M/B is not connected. See manual for location of CDIN.
The sound and everything else works fine except that the recorder and microphone
do not work. What is wrong?
1. Please go to sound properties and check if the recorder and microphone are enabled in
the audio rack.
2. Check if the Microphone is ok.
SY-P4VGM V1.0 Quick Start Guide
25