Tv Channel Setting - Venturer PLV16100 Instruction Manual

TV SETUP

TV CHANNEL SETTING

1. Press the MENU button.
2. Use the or
SETTING.
3. Use the or
(Antenna / Auto Scan / Auto Scan Add CH
/ Channel Skip / Channel No. / Channel
Label).
4. Use the or
The screen will change to your selected mode
immediately. Press the MENU button to return
to the previous menu.
5. Repeat steps 2 to 4 to adjust other options.
6. To exit the TV SETUP MENU and return to the
normal screen, press the MENU button on the
remote control.
NOTE
Channel No. : 2-69 Channel for Air, 1-135
Channel for CATV.
Antenna :
Auto Scan :
Auto Scan Add CH : The stored channels can not be cleared and the
Channel Skip:
Channel Label:You may edit one label for each channel.
1. Select the Channel Label item and press the
channel label edit screen.
2. Use the or
3. Use the or
4. After editting, press the DISPLAY button and the Channel & Channel
Label will be shown on the screen.
E
13
button to select TV CHANNEL
button to select the options
button to make adjustment.
Select "CATV" to receive cable signal. Select
"AIR" to receive over-the-air signal..
Automatically search all channels for those with
adequate signal strength.
Auto Scan Channels will be added.
If you has selected CATV in TV CHANNEL
SETTING, then you can select Cable System
(AUTO / STD / HRC / IRC) in the sub menu as
the picture shown.
You may switch ON/OFF the skip function of each
stored channel by selecting the channel with
button (and using
if the amount of stored channels in more than 1
page), and followed with pressing the ENTER
button.
button to enter the number or letter.
button to move and edit for the next character.
/ button to select page
button to go into the
/