Mercedes-Benz SL Operator's Manual page 66

Driving safety systems
64
Automatic emergency braking cannot prevent
a collision. There is a risk of an accident.
Always apply the brakes yourself and try to
take evasive action.
G
WARNING
®
PRE-SAFE Brake cannot always clearly
identify objects and complex traffic
conditions.
In these cases, PRE-SAFE
give an unnecessary warning and then
R
brake the vehicle
not give a warning or intervene
R
There is a risk of an accident.
Always pay particular attention to the traffic
situation and be ready to brake, especially if
®
PRE-SAFE Brake warns you. Terminate the
intervention in a non-critical driving situation.
In particular, the detection of obstacles can
be impaired if there is:
dirt on the sensors or anything else
R
covering the sensors
snow or heavy rain
R
interference by other radar sources
R
the possibility of strong radar reflections,
R
for example in parking garages
a narrow vehicle traveling in front, e.g. a
R
motorbike
a vehicle traveling in front on a different line
R
relative to the center of your vehicle
G
WARNING
®
PRE-SAFE Brake does not react:
to people or animals
R
to oncoming vehicles
R
to crossing traffic
R
when cornering
R
As a result, PRE-SAFE
give warnings nor intervene in all critical
situations. There is a risk of an accident.
Always pay careful attention to the traffic
situation and be ready to brake.
®
Brake may:
®
Brake may neither
In order to maintain the appropriate distance
to the vehicle in front and thus prevent a
collision, you must apply the brakes yourself.
X
To activate/deactivate: activate or
deactivate PRE-SAFE
Y
board computer (
®
When PRE-SAFE Brake is activated, the
Ä symbol appears in multifunction
display, as long as the HOLD function is
deactivated ( Y page 176). On vehicles with
Active Parking Assist, the Ä symbol is
displayed when P is engaged or you are
driving faster than 22 mph (35 km/h).
®
For PRE-SAFE Brake to assist you when
driving, the radar sensor system must be
switched on ( Y page 218) and be
operational.
Following damage to the front end of the
vehicle, have the configuration and operation
of the radar sensors checked at a qualified
specialist workshop. This also applies to
collisions at low speeds where there is no
visible damage to the front of the vehicle.
i USA only: This device has been approved
by the FCC as a "Vehicular Radar System".
The radar sensor is intended for use in an
automotive radar system only. Removal,
tampering, or altering of the device will void
any warranties, and is not permitted by the
FCC. Do not tamper with, alter, or use the
device in any non-approved way.
Any unauthorized modification to this
device could void the user's authority to
operate the equipment.
i Canada only: This device complies with
RSS-210 of Industry Canada. Operation is
subject to the following two conditions:
1. This device may not cause interference,
and
2. this device must accept any interference
received, including interference that may
cause undesired operation of the device.
Removal, tampering, or altering of the
device will void any warranties and is not
®
Brake in the on-
page 214).