Pre-Programming - LG-Nortel ipLDK-60 Installation Manual

ipLDK-60 Hardware Description and Installation Manual
STARTING THE ipLDK-60
6.2.2.1 Permanent Update Procedure
To accept changes while programming, perform the following Steps:
38. Press the [HOLD/SAVE]button when all changes have been entered to store the data permanently.
39. A confirmation tone should be heard when pressing the [HOLD/SAVE] button if all data was
entered correctly. If there were any errors in the entering of data, an error tone will be presented
and data will not be stored in the permanent memory.
6.2.2.2 Resetting the System
To reset the System, perform the following:
40. Enter [PGM] +450 then [FLEX] +15 and press the [HOLD/SAVE] button.

6.2.3 Pre-Programming

6.2.3.1 Location PGM – Nation Code and Site Name (PGM 100)
NOTE—The 4th pole of the DIP switch (SW1) on the MBU must be turned ON.
Nation Code
To program the Nation Code, perform the following Steps:
41. Press the [TRANS/PGM] button + PGM number (100) then [FLEX1] + 55 [Nation Code for Brazil].
42. Press the [HOLD/SAVE] button to accept the change.
43. Now Rest ipLDK-60 to initialize Database for Nation.
44. Set the 4
programmed features.
Site Name
45. Press the [TRANS/PGM] button +Enter Site Name (use the following DKT Map, Max. 23
characters allowed), then press [FLEX2].
46. Press the [HOLD/SAVE] button to accept the change.
th
pole (SW1) of the MBU OFF when the System operates normally, to protect
DKTU CHARACTER BUTTON MAP
Q – 11 A - 21
Z – 12 B - 22
. – 13 C - 23
1 – 10 2 - 20
G – 41 J - 51
H - 42 K - 52
I - 43 L - 53
4 – 40 5 - 50
P – 71
T - 81
Q –72
U - 82
R - 73
V - 83
S - 74
8 - 80
7 – 70
*1 - Blank
*2 - : 0-00
*3 - ,
D - 31
E - 32
F - 33
3 - 30
M - 61
N - 62
O - 63
6 - 60
W - 91
X - 92
Y - 93
Z - 94
9 - 90
60
Issue 1
JAN, 2007