Table of Contents
Advertisement
Monitor Output Connector [MON 1] / [MON 2 (SPOT)] / [MON 3 (VGA)]
A [MON 3 (VGA)] connector is provided so that you can use a standard, multi-sync computer monitor as your
main monitor. Use the cable supplied with your monitor to connect it to the recorder.
Connect the main monitor to the [MON 1] connector. Connect the spot monitor to the [MON 2 (SPOT)]
connector as needed.
Note: The [MON 3 (VGA)] and [MON 1] (BNC) connectors may be connected to individual
monitors for simultaneous operation.
Please keep away cables and other cables which have a lot of noises, lightning and surge.
Factory Reset Switch
The recorder has a Factory Reset switch to the left of the [MON 3 (VGA)] connector (4-channel model : the
right of the Serial Port) on the rear panel. This switch will only be used on the rare occasions that you want to
return all the settings to the original factory settings.
Important: When using the Factory Reset Switch, you will lose any settings you have
saved. (Excluded camera titles you can change in the Web Browser.)
To reset the unit, you will need a straightened paperclip:
1. Turn the recorder off.
2. Turn it on again with insert the straightened paperclip into the unlabeled hole in the left of the [MON 3
(VGA)] connector (or the right of the Serial Port : 4-channel model).
Note: Continue inserting until the internal buzzer starts to sound. (approximately 30 seconds
after turned on)
3. Release the reset switch. All of the recorder's settings are now at the original settings it had when it
left the factory.
Power Inlet [AC IN]
Connect the provided AC power cord to the recorder and then to a wall outlet.
WARNING:
ROUTE POWER CORDS SO THAT THEY ARE NOT A TRIPPING HAZARD.
MAKE CERTAIN THE POWER CORD WILL NOT BE PINCHED OR ABRADED
BY FURNITURE. DO NOT INSTALL POWER CORDS UNDER RUGS OR
CARPET.
THE POWER CORD HAS A GROUNDING PIN. IF YOUR POWER OUTLET
DOES NOT HAVE A GROUNDING PIN RECEPTACLE, DO NOT MODIFY THE
PLUG. DO NOT OVERLOAD THE CIRCUIT BY PLUGGING TOO MANY
DEVICES IN TO ONE CIRCUIT.
Your recorder is now ready to operate. Refer to "Chapter 3 -- Configuration" and "Chapter 4 -- Operation".
17
Advertisement
Table of Contents
