Safety Instructions - Festool PSC 420 EB Operating Manual

Charger
Mains voltage (input)
Mains frequency
Charging voltage (output)
Rapid charging
Conservation charging current, pulsating (only NiCd, NiHM)
Charging times for
Permitted charging temperature range
Temperature monitoring
Battery pack
Voltage
Capacity
Weight
5

Safety instructions

5.1 General safety instructions
WARNING! Read all safety warnings and all
instructions. Failure to follow the warnings
and instructions may result in electric shock, fire
and/or serious injury.
Save all warnings and instructions for future ref-
erence.
The term "power tool" in the warnings refers to
your mains-operated (corded) power tool or bat-
tery-operated (cordless) power tool.
5.2 Machine-related safety instructions
– Hold power tool by insulated gripping surface,
when performing an operation where the cut-
ting accessory may contact hidden wiring. Cut-
ting accessory contacting "live" wire may make
exposed metal parts of the power tool "live" and
could give the operator an electric shock.
– The charger and power tool are not intended for
use by persons (including children) with limited
physical, sensory or mental ability or without
sufficient experience and/or knowledge, unless
they are supervised by a person responsible for
their safety or have been instructed on how the
charger or power tool is to be used.Children
should always be supervised to ensure that they
do not play with the charger or the power tools.
– Festool electric power tools must only be in-
stalled on work tables provided by Festool for
this purpose. If the tool is installed in another, or
self-made, work table, it can become unstable
and result in serious accidents.
LiIon 1.5 Ah/ 3.0 Ah, 80 %
LiIon 1.5 Ah/ 3.0 Ah, 100 %
BPS 15 Li
14,4 V
2,6 Ah
0,58 kg
BPC 15 Li
14.4 V
3.0 Ah
0,55 kg
– Wait until the power tool stops completely until
placing it down. The tool can become entangled
and lead to a loss of control of the power tool.
– Do not open the battery pack or the charger. Even
after disconnection from the mains, there is still
a high capacitor voltage inside the charger.
– Make sure that metal objects (such as metal
chips) or fluids do not enter the machine through
the battery pack retaining slots (danger of short
circuit).
– Do not charge battery packs from other manu-
facturers. The charger is designed for charging
original battery packs only. Never charge the bat-
tery packs in chargers from other manufactur-
ers. Otherwise there is a danger of fire and
explosion.
– Protect the battery pack from excessive heat or
constant heat sources such as sunlight or naked
flames. There is a risk of explosion.
– Never use water to extinguish burning li-ion
battery packs, always use sand or a fire blanket.
– Deformed or cracked saw blades and saw blades
with blunt or broken cutting edges must not be
used.
– Always place the pendulum jigsaw on the work-
piece with the saw blade running.
– Wear suitable protection such as ear protection,
safety goggles, a dust mask for work which gen-
C A R V E X
GB
TRC 3
220 - 240 V ~
50/60 Hz
7.2 - 18 V=
max. 3 A
approx. 0.06 A
approx. 25/ 55 min
approx. 35/ 70 min
-5 °C to +45 °C
via NTC resistor
BPC 18 Li
18 V
2,6 Ah/ 3.0 Ah
0,67 kg
15