Table of Contents
Advertisement
G.dmt first (default), Autosense - T1.413 first, G.dmt/G.lite, T1.413, G.dmt, and G.lite.
Wiring Selection: It allows you to enter the wiring selection for the RJ-11.
Tip/Ring is the default for the Router without the inner/outer pair relay. Available types are Auto, Tip/Ring
(default), and A/A1, where Tip/Ring is the inner-most pair of wires on the RJ11 and A/A1 is the second
inner-most pair.
Bit Swapping: It allows you to enable or disable the upstream bit swapping. Bit Swapping is disabled by
default.
6.4 Route Table
The Route Table page displays the routing table and allows you to manually enter a routing entry. The
routing table will display the routing status of Destination, Netmask, Gateway, and Interface. The interface
br0 indicates the USB interface (reserved function); lo0 indicates the loopback interface; ppp1 indicates the
PPP interface. The Gateway is the learned Gateway.
l
The Gateway field of the static route entry allows users to either enter a Gateway IP address or select
a Network Interface.
l
All user-defined routes retained in the CPE memory, regardless if they are already in the Routing
Table, are displayed on the same Route Table page.
l
All user defined route entries kept in the CPE memory during run time are saved to flash when the
user chooses to save and reboot the CPE. When the CPE restarts, it reloads all saved user-defined
routes to the CPE memory and tries to apply to the system.
l
A user-defined route entry is added to the Routing Table whenever the system provides an
environment that makes the route entry applicable. It is removed from the Routing Table whenever
the route entry becomes not applicable. e.g. If the route entry's Gateway is associated with a dynamic
Network Interface but the connection is not established, then the route entry does not appear in the
Routing Table. When that interface comes up later, the route entry is then added.
29
Advertisement
Table of Contents
