Volvo XC90 Installation Instructions Manual page 17

Installation instructions, accessories - Navigation system, RTI Installation instructions, accessories - Navigation system, RTI
Volvo Car Corporation Göteborg, Sweden Volvo Car Corporation Göteborg, Sweden
37
38
39
© VolvoCar Corporation, 2007 Printed in Sweden © VolvoCar Corporation, 2007 Printed in Sweden
Installing the keypad in the steering wheel
Insert a screwdriver in the hole along the rear edge of the steering wheel
perpendicular to the rear surface of the steering wheel.
Insert the screwdriver as far as possible to find the end of the locking spring (1).
Place the end of the screwdriver on the top of the locking spring.
Move the screwdriver upwards towards the upper edge of the hole (2) until the
spring releases and one side of the steering wheel module detaches from the
M6400670 mounting.
Turn the steering wheel 180° and repeat the operation on the other side.
Turn the steering wheel to a neutral position.
Installing the keypad in the steering wheel
Fold the steering wheel module out
Unplug the two connectors (1) to the airbag transmitter cables.
Note!
The connectors are tightly secured. However, tools must not be used when
removing.
R6400818
Place the steering wheel module to one side.
Installing the keypad in the steering wheel
Remove:
the screw (1) and detach the ground lead.
the horn connector (2) and keypads.
the three screws (3) and lift out the horn ring (4).
R6400819
31260737 31260737
Page 17 of 20