Operating Instructions Operating Instructions - Sylvania Air Conditioner Owner's Manual

OPERATING INSTRUCTIONS
ION button(optional)
8
Press the ION button, the ion generator
is energized and will help to remove
pollen and impurities from the ai , and
trap them in the filter. Press it again to
stop the function.
SWING button
9
(Applicable to the models with auto swing feature only)
When the operation is ON, press
SWING button to stop the louver at
the desired angle. The louver swing up
O
to an angle of 6 for each press. Keep the
button pressed for more than 2 seconds
initiate the auto swing feature.
Operating Instructions
COOL operation
- Press the "MODE" button until the "COOL"
indicator light comes on.
- Press the ADJUST buttons " " or "
select your desired room temperature. The
temperature can be set within a range of
O O O
17 C-30 C/62 F-88 F.
- Press the "FAN SPEED" button to choose the
fan speed.
DRY operation
- Press the "MODE" button until the "DRY" indicator
light comes on.
- Under this mode, you cannot select a fan speed or
adjust the temperature. The fan motor operates at
LOW speed.
- Keep windows and doors closed for the best
dehumidifying effect.
- Do not put the duct to window.
AUTO operation
- When you set the air conditioner in AUTO
mode, it will automatically select cooling or fan
only operation depending on what temperature
you have selected and the room temperature.
- The air conditioner will control room
temperature automatically round the
temperature point set by you.
- Under AUTO mode, you can not
select the fan speed.
6
the
" to
O
FAN operation
- Press the "MODE" button until the
"FAN" indicator light comes on.
- Press the "FAN SPEED" button to
choose the fan speed. The temperature
cannot be adjusted.
- Do not put the duct to window.
TIMER operation
- When the unit is on, first press the
Timer button, the TIMER OFF
indicator light illuminates. It indi-
cates the Auto Stop program is
initiated.
- When the unit is off, first press the
Timer button, the TIMER ON indic-
ator light illuminates. It indicates
the Auto Start program is initiated.
- Press or hold the UP or DOWN
button to change the Auto time by
0.5 hour increments, up to 10 hours,
then at 1 hour increments up to 24
hours. The control will count down
the time remaining until start.
- The selected time will register in 5
second and the system will autom-
atically revert back to display the
previous temperature setting.
- Turning the unit ON or OFF at any
time or adjusting the timer setting
to 0.0 will cancel the Auto Start/
Stop timed program.
- When the malfunction (E1 or E2)
occurs, the Auto Start/Stop timed
program will also be cancelled.
SLEEP operation
res sing this button, the selected temperature
will increase(cooling) or decrease(heating)
O O
by 1 C/2 F in 30 minutes. The temperature
will then increase(cooling) or decrease
(heating) by another 1
additional 30 minutes. This new temper-
ature will be maintained for 7 hours
before it returns to the originally selected
temperature. This ends the Sleep mode
and the unit will continue to operate as
originally programmed.
NOTE: This feature is unavailab e under
FAN or DRY mode.
O O
C/2 F after an