Air Conditioner Features; Electronic Control Operating Instructions - Sylvania SYL-08PE Owner's Manual

ELECTRONIC CONTROL OPERATING INSTRUCTIONS

Before you begin, thoroughly familiarize yourself with the control panel and remote controller
and all its functions, then follow the symbol for the functions you desire.
The unit can be controlled by the unit control panel alone or with the remote controller .
NOTE: This manual does not include Remote Controller Operations, see the <<Remote
Controller Instruction>> packed with the unit for details.
OPERATION PANEL OF THE AIR CONDITIONER
(The models that do
not have this feature
do not have this button)
AUTO AUTO COOL COOL
HEAT HEAT DRY DRY
FAN FAN
Fig.4
MODE select button
1 1
Selects the appropriate operating mode.
Each time you press the button, a mode
is selected in a sequence that goes from
AUTO, COOL, DRY, F AN and
in cooling-only models).
illuminates under the different mode settings
Fig.4.
2 2
TIMER button
Used to initiate the AUTO ON start time and
AUTO OFF stop time program, in conjunction
with the & buttons.
3 3
POWER button
Power switch on/off.
SLEEP button
4 4
Used to initiate the SLEEP operation.
5 5 FAN button
Control the fan speed. Press to select the fan
speed in four steps-LOW, MED, HI and AUTO.
The fan speed indicator light illuminates under
different fan settings except AUTO speed.
AUTO fan speed is selected, all the fan indicator
lights turn dark.
9 9
6 6
SWING SWING
F
TIMER ON TIMER ON
MODE MODE
TIMER OFF TIMER OFF
2 2
1 1
HEAT(Not available
The mode indicator light
When

AIR CONDITIONER FEATURES

8 8
7 7
6 6
ION ION
C
SLEEP SLEEP
4 4
3 3
UP( ) and DOWN(
6 6
Used to adjust (increasing/decreasing)
temperature settings(1 C/2 F increments)
in a range of 17 C(62 F) to 30 C(88 F) or
the TIMER setting in a range of 0~24hrs..
NOTE: The control is capable of displaying
temperature in degrees Fahrenheit or degrees
Celsius. To convert from one to the other, press
and hold the Up and Down buttons at the same
time, for 3 seconds.
7 7
LED Display
Shows the set temperature in
O
F and the Auto-timer settings.
While on DRY and FAN modes, it shows
the room temperature.
Error codes:
E1- Room temperature sensor error-
Unplug the unit and plug it back in.
If error repeats, call for service.
E2- Evaporator temperature sensor error-
Unplug the unit and plug it back in.
If error repeats, call for service.
E4- Display panel communication error-
Unplug the unit and plug it back in.
If error repeats, call for service.
P1- Bottom tray is full - Connect the
drain hose and drain the collected
water away. If error repeats, call
for service.
Remote signal receptor
(Some models have the
signal receptor on the
front panel , Fig.2)
HI HI
MED MED
FAN FAN
LOW LOW
5 5
) button
O
C or
6