Working With The Machine; Service And Maintenance - Festool TI 15 Instruction Manual

Operating modes
Depending on the tool holder / adapter selected,
the machine is operated as follows:
Screwing with impact
– WH-CE CENTROTEC tool chuck (see
Chapter Tool chuck CENTROTEC WH-CE
[4])
Screwing and drilling without impact
– TI-FX adapter (see Chapter TI-FX adapter
[6])
• DD-AS elbow adapter
• DD-ES eccentric attachment
• DD-DC screwdriver attachment
– BF-TI 13 chuck (see Chapter BF-TI 13
chuck [5])
On/Off switch [1-2]
WARNING
Risk of injury
Only attach the power tool to the screw when
X
switched off.
Press = ON, release = OFF
L Depending on the pressure applied to the ON/
OFF switch the speed/impact rate can be con-
trolled continuously.
WARNING
Risk of injury, electric shock
Always disconnect the battery pack from the
X
machine before any maintenance or care work!
All maintenance and repair work which requires
X
the motor housing to be opened, must only be
carried out by an authorised service workshop.
Observe the following instructions:
– Keep the air slits on the machine and the charger
free and clean to ensure adequate cooling.
– Keep the contacts on the machine, charger and
battery pack clean.

Working with the machine

The LED lamp [1-4] lights up when the on/off
switch [1-2] is pressed and lights up the working
area.
The magnetic bit store is designed for holding bits
or bit holders.
The belt clip makes possible short-term fixing of
the device to work attire. The belt clip can be moved
to the right or left or can also be detached from the
battery pack.
Acoustic warning signals sound and the machine
switches off in the following operating states:
peep ― ―
peep peep ―
peep peep peep

Service and maintenance

Information on battery packs
– Where possible, store the battery pack in a cool,
dry place at a temperature between 5 °C and 25
°C.
– Battery packs are most efficient at temperatures
between 20 °C and 30 °C.
– Protect the battery pack from moisture, water
and heat.
– Significantly shorter operating times after each
charge indicate that the battery pack is worn and
should be replaced with a new one.
– The LiIon battery pack is fully compatible with the
charger! Integrated electronics prevent over-
loading and overheating during the charging pro-
cess.
Bit store [1-1]
Belt clip [1-9]
Acoustic warning signal
Battery flat or machine over-
loaded.
– Change the battery.
– Place the machine under reduced
stres.
Machine is overheating.
– You must allow the machine to
cool before using again.
LiIon battery pack is faulty or has
overheated.
– Once the battery pack has cooled,
perform a functional check using
the charger.
15