Unpacking; Contents Of The Shipping Containers; Tools Required For Assembly & Adjustment - Jet JTAS-10 Operator's Manual

Unpacking

Open shipping cartons and check that all parts are
intact. Report any damage immediately to your
distributor. Read the instruction manual thoroughly
for assembly, alignment,
instructions.

Contents of the Shipping Containers

1 XACTA Fence II
1 Front Rail
1 Rear Rail
1 Guide Rail
3 Black Plastic End Caps
1 Hardware Package
1 Owner's Manual
1 Warranty Registration Card
The contents of the hardware bag are drawn full
scale in Figure 1.
Note 1: Quantities may vary depending upon
whether you purchased the short rail or long rail.
Note 2: If the optional wooden extension table is
not used, there will be extra hardware.
Tools Required for Assembly &
Adjustment
1 #3 Cross Point Screwdriver
1 7/16" Wrench
1 1/2" Wrench
1 Combination Square & Straight Edge
1 Electric Drill
1 1/4", 3/16" Drill Bits
2 4"-6" C-Clamps
1 1/4", 3/16" Allen Wrenches
and maintenance
6