Verizon 4G LTE Get To Know page 7

The table below describes possible states for each of the device indicators:
Wi-Fi Solid blue
Blinking blue
Off
LAN Ports Solid green
Blinking
Off
WAN Port Solid green
Blinking
Off
4G LTE Solid blue
Off
Signal Strength Solid blue
Solid green
Solid amber
Off
Restore Factory To reset the router, locate the reset button (small hole outlined in red) on the
Settings bottom panel of the router. While the router is powered off, insert a paperclip
into the hole and gently push down the button for six (6) seconds. Depressing
the reset button causes the Power LED to blink briefly. After the reset button
is held down for more than 6 seconds, the Power LED will momentarily flash
amber, and then turn green as the router resets to the factory default
settings.
Note: Resetting the router will erase any changes you have made to the
default settings.
The Wi-Fi local access point is initialized.
Data is being transferred over the Wi-Fi link.
The wireless access point is turned off.
The local Ethernet ports have detected wired
links with computers or other Ethernet
devices.
Data is being transferred.
No link is detected on these ports.
The Ethernet WAN port has detected an active
link.
Data is being transmitted or received.
No link is detected on these ports.
4G LTE coverage is established for router.
No 4G LTE coverage is detected.
Strong signal is detected.
Good signal is detected.
Weak signal is detected.
No signal or service failure detected.
5