Trane 4MXW6-A Owner's Manual page 11

Notice: This is a general use remote controller, and not all features may be included
with your system. Some buttons may be de-activated.
Remote control
will also depend on the circulation sequence stated above.
MS-SVU42A-EN
Name and function of wireless remote control
SWING UP and DOWN Button
Press this button to select and set up the swing
angle as shown in the sequence below:
OFF
This is an universal use remote controller.
If remote controller sends the following
three kinds of status that the swing status
of main unit will be:
When the guide louver start to swing up and
down, if turn off the Swing, the air guide louver
will stop at current position.
indicates the guide louver swings up
and down between that all five positions.
Under swing up and down mode, when the status is
switched from off to , if press this button agian 2s
later, status will switch to off status directly; if press
this button again within 2s, the change of swing status
TIMER ON
TIMER ON Button
To set the TIMER, press the Timer On
button (be certain the clock displays the
actual time). The "ON" signal will blink,
the signal will be concealed, and the
numerical display will become the timer
on setting. To adjust the time value of
the setting, press the + or - button during
the initial 5 second blinking period. Each
time the + or - button is pushed, the setting
will be changed by one minute. Hold the
+ or - button continuously to adjust the time
setting rapidly. First, the time setting is
adjusted in 10 minute intervals. Release
the + or - button and press the Timer On
button while the display continues to blink
for 5 seconds. The Timer On setting is now
active. Press the Timer On button once
agian to cancel this setting.
TIMER OFF
TIMER OFF Button
Use this button to set the TIMER
OFF time.
The method of setting is the same
as for TIMER ON.
I FEEL
I FEEL Button
When this button be pressed, the remote
controller senses its ambient temperature and
keep sending signals to the air conditioner's
PCB every 10 minutes, then the latter
adjusts the capacity output accordingly
so as to maintain the room temperature
at the most comfortable level. To retain this
operation, the remote controller should be
kept pointing at the indoor unit so as to
guarantee smooth communication. If the air-
conditioner does not receive signal within 11
minutes, it will run according to the temperature
sensed by itself.
Remote Control Operation
11