4 Replacement Procedures
4.18 RGB/USB board
Removing the RGB/USB board
To remove the RGB/USB board, follow the steps below and refer to Figure 4-36 and 4-37.
1. Disconnect the RGB harness from the connector CN9611 on the RGB/USB board.
2. Remove the following screw securing the RGB/USB board.
•
M2.5×6C
4-64
[CONFIDENTIAL]
Tapping screw
M2.5x6C Tapping
Figure 4-36 Removing the RGB/USB board (1)
TECRA M11/Satellite Pro S500M Series Maintenance Manual (960-813)
×1
RGB harness
4.18 RGB/USB board
CN9611