Table of Contents
Advertisement
TV TUNER OPERATION
Accessing TV Mode
To switch to TV mode, press the TV button (16) on the front
panel or press the SRC button (8) on the remote control until
TV appears at the bottom of the screen.
NOTE: Touch the top left corner to access the MAIN
MENU Multi-ZONE SETUP menu and the top right corner
to access the Multi-ZONE menu (rear zone setup).
Auto Tuning
Press the
button (19) on remote control, or the
on the joystick (9) to seek the next available TV station by
increasing the tuning frequency.
Press the
button (17) on the remote control, or the
button on the joystick (8) to seek the next available TV station
by decreasing the tuning frequency.
Press the
/BAND,
,
,
or
button to stop
searching.
Once a TV station is searched, the auto seeking stops and
the TV station is played. If no station is searched, the tuning
stops at the first channel after performing a round search.
Manual Tuning
Press and hold the
or
buttons (8, 9) on the joystick to
increase or decrease the TV frequency one step.
Storing Stations (AS)
Automatic Preset Memory
To select the strong stations in the current TV frequency
range, press and hold the joystick button (5) to activate the
Auto Store function. The new stations replace stations
already stored. Press the joystick button again or press the
/BAND button (20) on the remote control to stop searching.
Using Preset Scan
To scan stored stations:
1.
Press the joystick button (5) to scan all stored TV sta-
tions. The unit pauses for 10 seconds at each station.
2.
Press the joystick button again or press the
button (20) on the remote control to stop scanning and
play the current station.
Selecting a TV Station
To browse through stored stations:
•
Press the
button (15) on the remote control or the
button (6) on the joystick to tune to the previous stored
station.
•
Press the
button (22) on remote control or the
button (7) on the joystick to tune to the next stored
station.
Direct Channel Selection
Use the numeric keypad on the
remote control (29) to enter a
specific TV station.
Display Current Channel
Press the DISP button (10) on the
remote control to display
button
information regarding the current
TV station.
/BAND
22
VM9020TS
Advertisement
Table of Contents
