Bang & Olufsen BEOLINK VIDEO User Manual page 6

6
Before you start using the sys-
tem, a few steps related to your
particular setup must be carried
out.
Programming the AV setup
Your extra TV requires program-
ming of the AV setup in order
to react properly when operat-
ed via the remote control.
Find your TV in the chart on
this page, and program the AV
setup as explained (the factory
setting of the TV is Option 1.
To program the TV back again,
just follow the instructions,
but press 1 instead – or select
TV: OPTION 1).
The programming is done
with the remote control, and
with the main system switched
to stand-by!
R E A D Y F O R
Beovision model:
MX 7000/6000/4000 (Beo4)
MX 7000/6000/5500/4000/3500
and
LX 6000/5500/5000/4500/4000
(Beolink 1000)
MX 5000/4500/3000
LX 2802/2502
LX 2800/2500 (with built-in
Datalink module)
Video transmission frequency
When, from the link room, you
start a video source using the
remote control, e.g. SAT or
V.TAPE, your extra TV automa-
tically switches to the correct
program number (as indicated
in the chart on the next page),
and you will be able to watch
the main video source on the
extra TV.
If your main video system is
built around a Beovision MX/
LX of the above mentioned
models and a Bang & Olufsen
video tape recorder, your ex-
tra TV is factory preset to the
video transmission frequencies
of the main system.
U S E ...
Programming sequence:
Hold the • button while pressing
LIST. When the Beo4 display reads
OPTION?, press GO. Press LIST to
display V.OPT and then select 2
While the TV is in stand-by mode,
press PICTURE, 2, STORE
While the TV is in stand-by mode,
press PICTURE, 2, STORE and
then PICTURE, 5, STORE
Switch on the TV. Press SHIFT, TEXT
to see the screen display. Then
select TV: OPTION 2 and TV:
MASTER
Follow the instructions in the
installation guide for the Data
link module
However, if your TV in the main
room is of a model with a built-
in system modulator (e.g. a Beo-
Vision Avant), which transmits
the signals from the main video
sources on one frequency, find
your extra TV in the chart on
the next page and follow the
instructions.