BMW K 1200 GT Rider's Manual page 117

Quick-release axle in
threaded bush
37 lb/ft (50 Nm)
Tighten the right-hand axle
clamping screw 5 with the ap-
propriate torque.
Clamping screw on
quick-release axle in
wheel carrier
14 lb/ft (19 Nm)
Remove front wheel stand.
Install securing screws 2 on left
and right with specified torque.
Front brake caliper on
wheel carrier
22 lb/ft (30 Nm)
The cable of the ABS sen-
sor could chafe through if
it comes into contact with the
brake disk.
Make sure that ABS sensor cable
is routed correctly.
Insert ABS sensor cable in
three retaining clips 3.
Route ABS sensor cable be-
tween brake caliper and front
suspension as shown in illus-
tration.
Remove adhesive tape from
wheel rim.
8
115
z