Argox OS Series User Manual page 33

LED Indicators: Power and Ready LEDs blink alternately
Power LED Ready LED
ON OFF
OFF ON
Possible Problems Solutions
Ribbon out Supply the ribbon roll
Ribbon jam Recover the jam
Ribbon sensor error Replace ribbon sensor
Note: For models OS-203/OS-204 this error will not occur.
LED Indicators: Only the Power LED blinks
Power LED Ready LED
ON ON
OFF ON
Possible Problems Solutions
Serial IO error Check the baud rate
Memory full Add the extension RAM
Cutter failed, or jam Check the cutter
at cutter Recover the jam
Hardware error Call for service
60
Remarks
Not applicable to
direct thermal
type.
Remarks
Not for Centronics
Occurs only when
installing or setting the
cutter
LED Indicators: Only the Ready LED blinks
Power LED Ready LED
ON ON
ON OFF
Possible Problems Solutions
Print head too hot Printing will stop until the
print head cools to an
acceptable printing
temperature. When it
does, the printer will
automatically resume
operation.
Printer is receiving Wait for the data
data transmission finished
Remarks
61