Argox OS Series User Manual page 10

4. Unwrap the ribbon roll pack and separate the ribbon roll
and the bare core.
5. Attach the edge of the ribbon on the bare core and wind it
a little bit onto the core.
6. Insert the ribbon roll into the supply holder. (First snap in
the left side and then the right side.)
Ribbon Supply Holder
14
Ribbon Roll
Bare Core
7. Put the print head module down and insert the bare core
into the pick-up holder. (First snap in the left side, and
then the right side.)
Ribbon Pick-up Holder
8. Turn the wheel of the print head module to ensure the
ribbon is tightly wound.
9. Press down the print head module firmly until you hear a
snap.
15
Bare Core